Sunday, March 31, 2019

Machine Tool Safety

As I look at the scar on my left index finger, I am reminded of how fast a machine tool can cause an injury. I was a teenager working in my grandmother's machine shop when it happened. I was using the large drill press to counter bore holes in the cutting edge of a bulldozer blade.

The drill press was very old and was definitely not built with safe operation in mind. I am not sure why, but the procedure involved sliding the heavy plate into position under the drill bit while the bit was still turning slowly in the chuck. I was wearing gloves to protect my tender hands from the sharp edge of the blade. The bit caught my glove, and although it was turning slowly, it began to wrap my finger around the bit all too quickly.

I was able to hit the power switch but the drill continued to coast until my whole arm was wrapped around the spindle. I reluctantly called to my grandmother for assistance. He traditionally turned the drill backwards as I unwrapped myself from the machine.

I was very lucky to have escaped with just a cut on my finger. I quick bandage and I was back to work; this time without gloves.

Machine tools can be very unforgiving when body parts are worn on or in them. The nature of the work also brings hands and fingers dangerously close to the rotating parts. It is easy to get accustomed to the promotion and get caught.

Gloves and loose clothing can easily get caught. Neckties should not even get close to the machines.

Procedures need to be developed to minimizeize exposure to the hazards. Making sure the rotating parts have stopped before relocating the work or taking measurements is one good place to start. I have seen many experienced machinist take caliper readings while parts are being cut in a lathe. Such practices endanger the worker and the equipment.

Guards are often a huge annoyance to machinists. However, if the guards are constructed of clear materials and made to easily open and close, they can add safety without interfering with the work to be done.

When developing procedures and procuring safety equipment, it is important to work closely with the machinists to make sure that the safety equipment does not interfere with the work. Otherwise, the safeties will be bypassed and procedures overlooked when supervision is not around.

Machine tools are a part of most modern workplaces. They can be used safely and effectively if proper precautions are taken.












  • Learning The Hard Way - Driving Lessons Hayleigh, a teenager in Coalville, passed her theory test just one day after her seventeenth birthday. Talk about being driven! In the course of the few weeks that followed, she went on to take some structured driving lessons. Some were cheap,…
  • Run Your Car With Water - Exploring Alternative Sources of Fuel In these times of ever increasing fuel prices, a lot of people are exploring alternative fuel sources that can help them reduce on the cost of fuel as well as help on solving environmental problems like air pollution and global warming. If you…
  • Stock Market Guide to Investing For Beginners As a general guide to investing: the stock market and investing for beginners is a bit like a riddle. All investors should understand the stock market because stock investing is the key to higher investment profits. At the same time, investing…
  • 0 Percent Interest Rate on Balance Transfer - It Can Happen As you begin to read through this informative article, give each point a chance to sink in before you move on to the next. A drill learner constantly faces many challenges for the active duration of his residence in the university. There are…
  • Ways to Invest Money - Enhance Your Retirement Income There are many ways to invest money; and if you are considering the stock market, what kind of results are you expecting? Are you looking for retirement income, a safe nest egg, or fast income? If you are interested in retirement income, you…